• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    To see this working, head to your live site.
    • Categories
    • All Posts
    • My Posts
    Drew Perttula
    Dec 08, 2021

    WLED 7W bulb GPIO configuration

    in Light

    My new bulbs only displayed green-or-off. I had to go to Config -> LED prefs -> Hardware setup -> GPIOs and fill them in:

    r 4

    g 12

    b 14

    w 13

    c 5




    0 comments
    0
    Comments

    Share Your ThoughtsSign up to leave a comment.

    0 comments
    Similar Posts
    • Tasmota to WLED
    • How to factory reset Athom WLED Bulb?
    • Upgrade firmware on 2M 7W bulb from v8.4.0

    ©2020 by athom.