• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    To see this working, head to your live site.
    • Categories
    • All Posts
    • My Posts
    Ayoze Aguiar
    Jan 20, 2021

    Is it possible to flash to tasmota from homekit, without open case, via web interface?

    in Plugs
    2 answers1 reply
    0
    3 Comments

    Share Your ThoughtsSign up to leave a comment.

    N
    Neil Heuer
    Neil Heuer
    Jul 31, 2021

    It can be done. When the switch is in AP mode you have to go to 192.168.4.1/update then you can upload your own bin file. On my 4 gang it just started clicking so you have to do the device recovery after that.


    Procedure~

    1. Cut power from the device completely for 30 seconds

    2. Power the device on and off six times with intervals lower than 10 seconds and leave it on after seventh time

    3. Fast power cycle device recovery should activate and the device should be reset to firmware defaults

    1

    Athom_Support
    Jun 02, 2021

    Does not support upgrading from homekit to Tasmota

    1
    3 comments
    Similar Posts
    • Flash Homekit version switch with Tasmota?
    • Is it possible to flash plugs from Tuya to tasmota over the air by raspberry with hotspot?
    • How to add tasmota wifi relay to homekit via homebridge?

    ©2020 by athom.