Discussion
So I'm getting "Upload buffer miscompare" when I try and upload a ESPHome firmware to overwrite Tasmota. I suspect it's because it's got a 1M flash, but I'm using "esp01_1m" for the board. I'm basinc my configuration on https://www.athom.tech/forum/plugs/here-is-an-esphome-config-for-the-uk-power-plug, even pulled out the daily KWh usage stuff, to try and get the bin down smaller. Even though the original was still under 512KByte. Anyone have any solution? Pull it open and flash over serial? substitutions:
devicename: deb_light_control
upper_devicename: Athom Smart Plug
# Higher value gives lower watt readout
current_res: "0.00225"
# Lower value gives lower voltage readout
voltage_div: "757"
esphome:
name: $devicename
platform: ESP8266
board: esp01_1m
wifi:
ssid: "SSID"
password: "SSID_PASSWORD"
# Enable fallback hotspot (captive portal) in case wifi connection fails
ap:
ssid: "${upper_devicename} Hotspot"
password: "PASSWORD"
captive_portal:
# Enable logging
logger:
# Enable Home Assistant API
api:
password: "PASSWORD"
ota:
password: "PASSWORD"
# Time used for daily KWh usage
#time:
# - platform: homeassistant
# id: homeassistant_time
status_led:
pin:
number: GPIO0
inverted: yes
binary_sensor:
# Button 1 configuration
- platform: gpio
pin:
number: GPIO3
mode: INPUT_PULLUP
inverted: True
id: button_1
on_press:
then:
- switch.toggle: relay_1
on_click:
min_length: 5000ms
max_length: 10000ms
then:
- switch.turn_on: reset
- platform: status
name: "${upper_devicename} Status"
switch: # Set relays as switches
- platform: gpio
id: relay_1
icon: mdi:power-socket-uk
pin: GPIO14
name: "${upper_devicename} Switch"
on_turn_on:
- switch.turn_on: sw_led1
on_turn_off:
- switch.turn_off: sw_led1
# Register LED on GPIO
- platform: gpio
id: sw_led1
pin: GPIO13
inverted: True
- platform: restart
name: "${upper_devicename} Restart"
id: reset
sensor:
- platform: hlw8012
sel_pin:
number: GPIO12
inverted: True
cf_pin: GPIO04
cf1_pin: GPIO5
current_resistor: ${current_res}
voltage_divider: ${voltage_div}
current:
name: "${upper_devicename} Amperage"
unit_of_measurement: A
accuracy_decimals: 3
icon: mdi:flash-circle
voltage:
name: "${upper_devicename} Voltage"
unit_of_measurement: V
icon: mdi:flash-circle
power:
name: "${upper_devicename} Wattage"
unit_of_measurement: W
id: "${devicename}_Wattage"
icon: mdi:flash-circle
change_mode_every: 4
update_interval: 10s
# - platform: total_daily_energy
# name: "${upper_devicename} Total Daily Energy"
# power_id: "${devicename}_Wattage"
# filters:
# Multiplication factor from W to kW is 0.001
# - multiply: 0.001
# unit_of_measurement: kWh
# icon: mdi:clock-alert
- platform: uptime
name: "${upper_devicename} Uptime"
icon: mdi:clock-outline
- platform: wifi_signal
name: "${upper_devicename} Wifi Signal"
update_interval: 60s
0