• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    To see this working, head to your live site.
    • Categories
    • All Posts
    • My Posts
    gaucho
    Jan 24

    Issues with UK PG04 Plug (pre-flashed Tasmota)

    in Plugs

    I just had 4 new pre-flashed plugs delivered from the Athom Aliexpress store. When I plug them in the Tasmota hotspot appears as expected, but every time I set the wifi information it reboots and connects the the AP but never becomes accessible. Specifically - the web interface never loads fully and the devices are not pingable. I can reset them (7 short power cycles) and get the setup AP up again... but then the same loop starts again.


    Am I doing something wrong?


    I have tried two different access points to make sure the problem isn't on that side. I have previously been using Gosund UP111 devices and flashing them myself with tuya-convert so I am not new to this... I just thought I'd try these pre-flashed devices to make things easier... but so far it hasn't worked out that way!


    Thanks for any ideas or guidance.

    0 comments
    0
    Comments

    Share Your ThoughtsSign up to leave a comment.

    0 comments
    Similar Posts
    • Flash Homekit version switch with Tasmota?
    • Athom plug manual re-flash
    • Is it possible to flash plugs from Tuya to tasmota over the air by raspberry with hotspot?

    ©2020 by athom.