My switches are working few minutes. After few minutes i can operate by phone or voice but it is impossible to change state of switch by touch. Please watch the movie
https://youtu.be/yUJsYQVQjXo
What is wrong?
top of page
To see this working, head to your live site.
11 Comments
Commenting on this post isn't available anymore. Contact the site owner for more info.
bottom of page
hello,
I had the same problem with three Athom 1Gang EU Swich.
That the touch button did not respond. And so I fixed it.
First I updated Tasmota to the latest version via OTA.
But the problem remained.
Then I took out the template and tried the configuration directly via Generic.
Problem remained.
Then I completely reset the configuration.
After restarting the device I was unable to connect to the Tasmota AP.
It was there but I couldn't connect to the Tasmota AP.
That's why I turned off the power of the switch.
The Tasmota AP could then be reconnected.
Configured via Generic without template.
Problem is gone.
I repeated the procedure on the other switches.
All switches work.
I hope this helps you.
greeting Martin