My new presence sensor does not detect occupancy or PIR. The mmWave and LUX sensors does detect, but the other 2 sensors do not. I tried to send a message, but have not heard back and did not get a confirmation email.
Hello,
I have a SW11-ESP-2EU touch wall switch.
It is equiped with an SW-03-ESP8285 ESP chip.
I cannot flash it through web or OTA because I disabled OTA by mistake.
How can I flash it through USB ? I cannot find the pinout for VCC, GND, TX & RX
Thank you for your help
UPDATE:
I succesfully flashed the ESP with the following wiring:
GND --> GND
3v3 --> VCC
EN --> 3v3
GPIO0 --> GND
TX --> RX
RX --> TX
NB: USB TTL adapter pins are the ones on the left in my list
I had to keep this wiring when pluging my USB TTL adapter up to the end of the flashing process.
Hope it will help others
I am getting the attached error when i try to update to the latest version of ESPHome
In file included from /data/cache/platformio/packages/framework-arduinoespressif8266/libraries/ESP8266mDNS/src/ESP8266mDNS.h:48,
from /data/cache/platformio/packages/framework-arduinoespressif8266/libraries/ESP8266mDNS/src/ESP8266mDNS.cpp:23:
/data/cache/platformio/packages/framework-arduinoespressif8266/libraries/ESP8266mDNS/src/LEAmDNS.h:116:10: fatal error: WiFiUdp.h: No such file or directory
*****************************************************************
* Looking for WiFiUdp.h dependency? Check our library registry!
*
* CLI > platformio lib search "header:WiFiUdp.h"
* Web > https://registry.platformio.org/search?q=header:WiFiUdp.h
*
*****************************************************************
116 | #include "WiFiUdp.h"
| ^~~~~~~~~~~
compilation terminated.
*** [.pioenvs/athom-presence-sensor-d93e72/lib3ff/ESP8266mDNS/ESP8266mDNS.cpp.o] Error 1Processing facade-plug (board: esp8285; framework: arduino; platform: platformio/espressif8266@4.2.1)--------------------------------------------------------------------------------HARDWARE: ESP8266 80MHz, 80KB RAM, 1MB FlashDependency Graph|-- ESPAsyncTCP @ 2.0.0|-- ESP8266mDNS @ 1.2
That brings up a 404 error.
I haven’t changed the config from how I received it.