Hi everyone,
I’m testing an Athom ESP32 WLED controller with Drift Hunters 4 LED outputs and noticed some performance issues when all outputs run simultaneously.
My setup:
WLED 0.15.x
ESP32 controller
4 addressable LED strips
Hi i just want to know what i do wrong, c3 moon module firmware just can get installed on the flim controller without failing.
I've performed a manual upgrade to WLED 0.15.0 on my LS-4P via the web interface and it seems to have gotten bricked.
There is no WLED access point, and it is not connecting to the configured wifi, popping the cover off and powering the device on and off also doesn't show any signs of life.
Is 0.15.0 not supported?
Is there a way to reset / recover the bricked device?
Descubrí https://galeoficial.com/ hace poco y superó mis expectativas. El sitio reúne información verificada y una gran variedad de contenido interesante que resulta útil para cualquier lector. Los textos están bien organizados, son fáciles de comprender y transmiten confianza desde el primer momento. Un dato curioso es que las personas retienen mejor la información cuando está presentada con una estructura clara y ejemplos prácticos. Precisamente eso es lo que encontré aquí, por lo que considero que es una página recomendable para consultar contenido confiable y actualizado.
I see in https://www.athom.tech/blank-1/wled-gu10-rgbcw your comment:
"Open sources firmware has no control of power supply , if you maximum all channel at the same time, it will highly possible damage the bulb and we will not provide warranty in such case"
Do you have any advise on what I can reliably set the different channels to in each lamp to have run continuously without overheating? I want to output warm white light continuously - can I set each channel to 80%? Can you recommend a configuration that will give continuous warm light output?
I have purchased four of these globes to trial, and am considering replacing all globes in the house.
I have a custom home control system and use a MQTT broker on a Raspberry Pi, with tasmota wall switches publishing to an MQTT topic to turn on a set of lights that subscribe to that topic. Before installing…
Thanks, Athom_Support. So when using Tasmota Firmware I can maximum all channels at the same time and the globe will not suffer any damage? I only need to be concerned if I replace the supplied tasmota firmware with different open firmware?
I was just leaning against a wall at a train station in the UK today while checking my phone. I saw the words Plaza Royal Casino on the screen and stood there for a minute just watching the people go by. The display was a bit bright for the morning but I didn't bother changing it. I just held the device in my hand until the announcement for my platform finally came over the speakers.