Hi! I haver updated The binaries of a athom bulb 15, i was wled and tried to change to esphome, but this proccess brick the device, how can i do this via the serial port? I noticed that it has gnd, vcc, but I don't know which pins are gpio0 and rx/tx.
top of page
To see this working, head to your live site.
Comments (3)
Commenting on this post isn't available anymore. Contact the site owner for more info.
bottom of page
Hello,
I have the same problem and was able to disassemble the plastic dome by steady gently pushing forward and backward to loosen the glue. I can see the pins corresponding to this.
But wich one is RX, TX, Gnd, 0, 3v etc?
Anyone Ideas?
Best
this is the only way